Forums Home > New Users > Installation on hollowbody bass?
Installation on hollowbody bass?
Replies for Installation on hollowbody bass?
Author Message
JUDSON91
Joined: March 2016
Posts: 0
Location:
WILMINGTON, NC
Posted: March 25, 2016 12:55 PM

Hello,
would Gizmotron have any interest in supplying longer vertical support screws? I am attempting to install a Gizmotron on a Gretsch 6119 hollowbody bass, and the screws cannot make the unit tall enough to seat properly about the strings.
Dong121
Joined: March 2016
Posts: 1
Location:
SIMI VALLEY, CA
Posted: March 28, 2016 2:50 AM
I was hoping to install it on my Duojet, but I have the same problem. I wish it came with an alternative set of longer ones or an adjustable way of raising it.
Gizmotron
Author Image
Joined: December 2011
Posts: 5
Location:
Fair Lawn, NJ
Posted: April 3, 2016 12:25 PM
Hi, there is a very easy way to extend the height of the Gizmotron, all you need is an M4 Hex Standoff with a male and female end. You can get a pack of 10 on ebay for less than $2.00 (These would give you a 6mm extension):

http://www.ebay.com/itm/10-pcs-M4-x-6mm-Brass-Hex-Standoff-Pillar-Male-Female-AK-Good-/181561861124?hash=item2a45ee2404:g:itUAAOxyOa9R299U

Simply thread the claw screw that comes with the Gizmo into the female end of the standoff, and then thread the male end of the standoff into the body.
256
Joined: December 2016
Posts: 1
Location:
Posted: December 15, 2016 7:06 AM
jdsg bugrr l
Our members have made a total of 18 posts
We have 302 registered members
FORUM RULES
You are not logged in.
You cannot post replies